Subject:
|
Re: Melting Point of ABS (Re: Strengthening Gears)
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 6 Mar 2002 14:43:30 GMT
|
Viewed:
|
5712 times
|
| |
|
|
In lugnet.technic, Jason S. Mantor writes:
> IIRC, ABS is a thermoset plastic.
No, it's thermoplastic. But too much heat, or even localized hot spots, can
scorch it and make it unusable.
|
|
Message is in Reply To:
 | | Re: Melting Point of ABS (Re: Strengthening Gears)
|
| IIRC, ABS is a thermoset plastic. The first time you melt it it's workable at a relatively low temp and solidifies nicely, but heating it again won't melt it, only deform it and finally burn it : ( -Xanthra47 Ross Crawford <rcrawford@csi.com> wrote (...) (22 years ago, 6-Mar-02, to lugnet.technic)
|
42 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
