Subject:
|
Re: Strengthening Gears
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 5 Mar 2002 14:27:56 GMT
|
Viewed:
|
3084 times
|
| |
|
|
In lugnet.technic, Jack Gregory writes:
> Plastic doesn't get stronger under heat-treatment. This type of heat
> treatment is used to control the crystallization of metals, and long-chain
> polymers like plastic just don't behave like that.
Yes, this is true.
> If you need stronger gears, double them. It is the axles that are the weak
> point generally, though.
Now that's quite a statement! I got an email yesterday from someone saying
that the axles were the weak point too.
I don't know how you're using your gears, but when something breaks in my
models, it's the gears!
http://www.texbrick.com/ideas/gears/
(see bottom of page)
TJ
|
|
Message has 1 Reply:
 | | Re: Strengthening Gears
|
| I have never broken a gear. But then, I am a mechanical engineer; I am nice to my gears. But I fry a lot of electronics! My experience is that the torsional stiffness of the axles is the limiting factor of high-torque designs. I have permanently (...) (22 years ago, 5-Mar-02, to lugnet.technic)
|
Message is in Reply To:
| | Re: Strengthening Gears
|
| Plastic doesn't get stronger under heat-treatment. This type of heat treatment is used to control the crystallization of metals, and long-chain polymers like plastic just don't behave like that. If you need stronger gears, double them. It is the (...) (22 years ago, 5-Mar-02, to lugnet.technic)
|
42 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
