Subject:
|
Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 4 Oct 1999 16:27:35 GMT
|
Viewed:
|
923 times
|
| |
|
|
On Sun, 3 Oct 1999 15:37:34 GMT, "Gary Williams" <graywolf@pcpros.net>
wrote:
> No.
>
> Our software will detect mirror operations and correct for them.
I've been thinking the exact opposite -- mirroring should be a valid method
for turning subfiles inside-out, and the software doesn't need to do
anything special to deal with it (except to notice the inversion, and pass
that info on to the subfile). That's the reason the 0 INVERT flag would be
needed -- to tell the rendering program that it needs to correct the
inversion for the following command.
Steve
|
|
Message has 1 Reply:
 | | Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
| Steve Bliss wrote in message <37f8c86b.239282689@...et.com>... (...) But more often than not, when mirroring an element or subassembly, it's not the intent of the author to turn it inside out. Typical model builders shouldn't concern themselves (...) (25 years ago, 4-Oct-99, to lugnet.cad.dev)
|
Message is in Reply To:
53 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
