Subject:
|
Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 30 Sep 1999 14:55:42 GMT
|
Viewed:
|
671 times
|
| |
|
|
John VanZwieten wrote in message ...
> What I was concerned about are situations where a single quad is used as • the
> outside of a section of a part and the inside of a section of a part. A
> theoritical example would be a minifig head. You could use a single 4-
> 4cyli.dat to model the outside of the top stud and the inside of the hole • in
> the bottom, since they are the same diameter. Of course that would be bad
> form.
What if the part that referenced such a primitive had a '0 invert' comment
on the line before the primitive reference, if that instance of the
primitive was intended to appear inside-out?
-Gary
|
|
Message has 1 Reply:
 | | Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
| Gary Williams <graywolf@pcpros.net> wrote in message news:FIvo77.F2B@lugnet.com... (...) In the case I'm talking about, 1 primitive is used in 1 instance to be both an outer face and an inner face. In this case, you'd have to fix it manually by (...) (25 years ago, 30-Sep-99, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: CW/CCW, vertex sequence, co-planar, convex, (115kB)
|
| (...) CW, (...) as (...) What I was concerned about are situations where a single quad is used as the outside of a section of a part and the inside of a section of a part. A theoritical example would be a minifig head. You could use a single 4- (...) (25 years ago, 30-Sep-99, to lugnet.cad.dev)
|
53 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
