| |
In lugnet.robotics.nxt.nxthacking, John Hansen wrote:
> If you haven't heard yet, IAR has released a free LEGO MINDSTORMS version of
> their compiler. It happens to be the same compiler that LEGO uses to build the
> NXT firmware so it makes it extraordinarily simple to build your own modified
> firmware images.
The download page has this nice little notice:
DISCLAIMER: You have to open the LEGO® MINDSTORMS® NXT and solder on PCB. Please
note that the LEGO Group warranty of the NXT is invalid after doing this.
Neither IAR Systems nor the LEGO Group will take any responsibility of damages
done to your NXT once it has been opened. We strongly recommend previous
knowledge of soldering on PCB and open electronics.
Is this required or intended for in circuit debugging?
I can see how it could un-brick after a bad firmware load.
|
|
| |
> Is this required or intended for in circuit debugging?
This is only for debugging purpose!
> I can see how it could un-brick after a bad firmware load.
Fortunately the processor has a special boot mode to recover from that without
ressorting to JTAG. But I appreciate the concept of "un-bricking a bricked NXT
brick" ;o)
Philo
|
|
|
