Subject:
|
Re: 4-6-4 Hudson Yellowbelly
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Mon, 30 Dec 2002 15:21:44 GMT
|
Viewed:
|
677 times
|
| |
|
|
Nice looking engine.
I am interested about your drive wheels. How good do they run. I always had
problems going over switches, and and with three drive wheels how will does
it fit over curves.
How are you connecting your drive wheel to your rods? I can't recognize the
piece(s) from the picture.
|
|
Message has 1 Reply:
 | | Re: 4-6-4 Hudson Yellowbelly
|
| (...) Thanks! (...) The drive wheels are only connected to the chassis by couplings, the top is "pressed on" the chassis by 2 springed wheels holders (the red ones). Over curves and switches, they puch up slightly higher, and therefore don't run. On (...) (21 years ago, 30-Dec-02, to lugnet.trains)
|
Message is in Reply To:
| | 4-6-4 Hudson Yellowbelly
|
| My latest train project is up on Brickshelf: (URL) is build after the 4-6-4 hudson shrouded steam engine ÿellowbelly". Only 4 have been made, but never went into service. The model is build in 8 wide, and is almost finished"... The undercarriage (...) (21 years ago, 27-Dec-02, to lugnet.trains)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
