To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 114
113  |  115
Subject: 
Re: 4,5 V replacement/9v compatibility
Newsgroups: 
lugnet.trains
Date: 
Fri, 6 Nov 1998 20:20:04 GMT
Viewed: 
2220 times
  
Dear Hans,
I'm not aware of any replacement motor sources but let me see if I have an
extra 4.5v motor unit in used/good condition.

Also, since the newer, 9v wheels (on both wheelsets and on the motor) are
narrower than their 4.5v counterparts, they tend to derail when negotiating
points (switches).

I'll check on the motor and will advise,
Dan Parker <danp@qi2.com>
PNLTC

Hans van Zandvoort writes:
My 4,5V train-engine failed recently. After opening it up (a problem in
intself because of the sealed box) i discovered that one of the brushes of the
electric motor broke of and destroyed part of the anchor.  Also the cupper
wiring burned out (mainly because of the quite strong short circuit-currect
from the nicad-battery's it was running on at that momment i suspect.

I'm looking for advise on repair or replacement

Specifically I would like answers to the following questions:

Where do i buy a replacement trainengine ?

Where do i buy an electric motor to replace the burnt one ?

Is it possible to let the 9V train motor (kit # 5300 i believe) run on the old
4,5V blue tracks (supposed i fix it with a 9 V- battery).  I'm specially
worried about the wheel profile being able to negotiate the points.

Is it possible to fix wheels with train-type flanges to the engine that looks • about the same as my old one but has technic-style axle holes ?

Does anyone have another idea to get me running again ?

Thanks in advance for bothering to reply !



Message is in Reply To:
  4,5 V replacement
 
My 4,5V train-engine failed recently. After opening it up (a problem in intself because of the sealed box) i discovered that one of the brushes of the electric motor broke of and destroyed part of the anchor. Also the cupper wiring burned out (...) (25 years ago, 3-Nov-98, to lugnet.trains)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR