Subject:
|
Re: Too much crane?
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Tue, 5 Mar 2002 18:25:44 GMT
|
Viewed:
|
1263 times
|
| |
|
|
In lugnet.technic, Mark Rideout writes:
>
> In all the pictures posted, one question is nagging me - what are the pieces
> that you are using for the mirror "arm" bracket. It looks like white tubing
> bent at the top and bottom, but for the life of me I cannot figure out how
> they are connected to the cab post. What's going on there?
Well spotted! It's a hack :-) The doors have had a triangle cut out of them
as they were so close to being perfect it would have been a shame not to use
them, and the mirror brackets are flex tubes bent to 90 degrees. They are
attached to a couple of pins (2M screws if I rememebr correctly) which were
screwed into very small holes drilled in the side of the doors. The flex
tubes then fit nicely over those. I have some photos of this process for
putting on my web site - it isn't a cover up, honest ;-)
Jennifer
|
|
Message is in Reply To:
 | | Re: Too much crane?
|
| (...) A real treat to the model-team and technic heads alike. As others, I cannot wait to read the write-up on your website. In all the pictures posted, one question is nagging me - what are the pieces that you are using for the mirror "arm" (...) (22 years ago, 4-Mar-02, to lugnet.technic)
|
31 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
