Subject:
|
Re: Shutdown/Off while program running crashes BrickOS
|
Newsgroups:
|
lugnet.robotics.rcx.legos
|
Date:
|
Sun, 17 Jun 2007 14:26:09 GMT
|
Viewed:
|
15313 times
|
| |
|
|
> > It sounds like the code is testing for pressing the run button, but not
> > pressing the power button.
>
> I'm using what appears to be called BrickOS 0.9.0. It was installed using
> John
> Hansen's simplified installation from his BricxCC sourceforge site.
Yes, that should be the latest version.
> I was under the impression that on later versions of BrickOS, like what I
> am
> using, the firmware handles the Run and Power buttons. My code does use
> the
> View and Prgm buttons but I do no special handling of the other two
> buttons
> other then monitoring shutdown_requested and exiting and killing all tasks
> when
> that is encountered.
That is correct. You shouldn't need to do anything else.
At one point, I made some changes to the firmware so the program could also
access the run button. But, normally all that is handled in the firmware.
We'll see if we can figure it out at Brickworld.
See you in a few days...
Steve
|
|
Message is in Reply To:
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
