To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.cybermasterOpen lugnet.robotics.cybermaster in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / CyberMaster / 154
153  |  155
Subject: 
Re: CyberMaster connection to BricxCC
Newsgroups: 
lugnet.robotics.cybermaster
Date: 
Sat, 23 Apr 2016 09:37:06 GMT
Viewed: 
30864 times
  
In lugnet.robotics.cybermaster, "Graham Hepworð" <terminal0@protonmail.ch>
wrote:
Hello, I am a new user to the Bricx Command Center.

Forgive me if bad English. I seek to connect my CyberMaster unit to Bricx
Command Center, though I get the error "No connection to the programmable brick"
upon each time started. I use the original CyberMaster tower connected via a USB
to serial adapter to my computer. My computer is 64bit and Windows 10. I have
heard of success in connecting to this brick and using Bricx Command Center. Any
helpful advice?

Thank you,


--Graham Hepworð

Answer: It is simple: I used the prolific usb to serial adapter, configured the
Serial communication to 9600,8,n,xon/xoff , took a NULL-Modem Serial Cable and
linkt pin 4 and 6 on the 9-pin connector together. After that communication to
the brick succeded on windows 10 for me. May this helps out



Message is in Reply To:
  CyberMaster connection to BricxCC
 
Hello, I am a new user to the Bricx Command Center. Forgive me if bad English. I seek to connect my CyberMaster unit to Bricx Command Center, though I get the error "No connection to the programmable brick" upon each time started. I use the original (...) (8 years ago, 27-Feb-16, to lugnet.robotics.cybermaster)

3 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR